Adding, Editing and Deleting Servers¶
In order for the user to connect to a server and be able to configure it, that server must be known to the web administration tool, and must be started and running.
Once the Denodo ITPilot administration tool has started up, it is possible to configure some parameters that affect this tool by clicking on Settings. It is important to note that only users with the maximum privileges (administrator permissions) may access these sections.
To access the configuration of the Denodo ITPilot administration tool a screen (Denodo ITPilot login screen to administrate the web tool) is shown in which the user will have to enter his/her credentials. There is one predefined user for this web administration tool with login “admin” and password initially set to “admin” (which can be changed after the user logs in by clicking on the button Change password).
Clicking the button, located below the server list, will show the page depicted in ITPilot servers administration page.
To add a new server to the tool, the user should click on the button located below the server list (see ITPilot servers administration page). He will be asked for the following information:
Type: the type of the server being added: Wrapper Server, Browser pool or Verification Server.
Name: server name. Used only to identify it within the web administration tool.
Host: host name or host address where it can be found.
Port: server listening port.
This information (except the name) can be modified later by clicking on the button.
Any number of servers can be added as needed, although the architectural considerations in section Distribution of Environments of this document should be taken into account.
Servers can be deleted from the administration tool by clicking on their associated buttons.